Installation

PAF Tektiles are quick and easy to install they can be laid over
existing floors with minimal surface preparation.

Tools required - Hard plastic mallet, and bench saw.

1. Repair any major surface imperfections in the floor. Large cracks, etc.
2. Using a hard plastic mallet, interlock tiles along the door openings.
   The idea is to have the tile cuts and smaller pieces along the edges
   and back of the building.
3. Continue into the building toward the back and sides. Leave a 10mm gap
   around the perimeter to allow for expansion and contraction.
4. Tiles can be cut using any tool capable of cutting vinyl flooring. Protective
   equipment and safety measures should always be followed.

Maintenance - The tiles can be cleaned with a diluted ammonia and water solution.
A power scrubber or buffer can also be used. No waxes or sealant should be used.

For an obligation free quote phone the helpline on 01933 403555 or download
the pdf floor grid below and fax 01933 403888 or email sales@pafsystem.com.