  |
 |
| Faq's Do I need to do anything to the floor? No, except for major cracks or missing cement pieces, no skim coating, sealing, sand blasting or detergent washing is necessary. Just sweep or blow out your garage and your ready to install. How do I clean the tiles? Ammonia and water will do just fine with a sponge mop. No waxes or sealers should be used. You can use a buffer with a lambs wool pad to buff a clean dry floor to an amazing shine. In fact, you can hose off the floor with your garden hose or a power washer. (under 1300psi). Can I use a floor jack? The tile will hold up fine to just about anything that you can put on it. It is a vinyl product, so it will compress under heavy loads. You can use a floor jack to lift a van or car on the tiles and won’t have any problems. Jack stands with sharp edges will cut into the tile, so be careful with them but floor jacks, engine stands, hoists, bottle jacks, toolboxes, etc. will be fine. You're best off simply putting a small piece of plywood underneath to dissipate the load, or just pop out the tile use the hoist, then pop them back into place What adhesive do I use to attach an Paf Tektile to the floor? None. The tiles form a floating floor. No adhesive is necessary. How long do I have to wait before I can use the floor? As fast as you install it! You can drive on the floor the same day. Can Paf Tektiles be installed over a painted floor? Yes. Do the tiles require a sealant once I’m done? No. What tools are required for your tile installation? A rubber mallet to properly connect the interlocks and a carpet knife or any other cutter suitable for vinyl tiles. Can I use these tiles outside? No, tiles are not manufactured for direct exposure to ultraviolet rays. What are Paf Tektiles made from? Tough PVC which is fully recyclable. |
 |
 |
 |
 |
 |
